Leaking Central Heating Pipes Detection Using A Thermal Camera

What Can The Thermal Imaging Camera Do?

The camera can be a powerful device for both central heating and plumbing engineers in detecting water leakage from hidden pipes located below floors.

It helps in locating the pipe routes without the need to remove or dig up any form of flooring, like tiles and hardwood flooring.

The camera removes the necessity for guess work on pipe locations and can in lots of cases detect the place any form of water leakage maybe.

What Type Of Camera Do I Want?

There are a lot of different types of thermal imaging cameras around today to select from, but in my experience the cheaper ones needs to be averted for detecting water leakage.

The perfect advise can be to take a look at the center priced range of camera, it will give higher image high quality and that image storage, as well locating water leakage underneath floors.

Central Heating Leak Detection

Overtime a longtime central heating system can and can develop some form of water leakage. This sometimes occurs when the boiler is replaced.

The old boiler worked with a small header tank positioned in the loft so was not beneath loads of pressure.

The new boiler is now pressurised and the header tank now not needed. The pipe work has solely been tested on low pressure so when converted to high pressure a leak could happen.

These types of leaks might not show up right away, they’ll cause damp patches to seem on ceilings and walls, even pressure loss from the central heating system. These leaks if left, can cause damage and need to be situated and repaired.

This is where the thermal imaging camera is available in, it may locate the water leakage and level you in the correct direction to repair the leak.

Does Your Heating System Need A Powerflush?

The central heating system if not handled with an inhibitor will suffer from sludge build up within the boiler, radiators and pipe work.

Sludge is caused by all the completely different metals related to the system, while you add water a conductor, a reaction is started and sludge starts to form.

When you have sludge in your central heating system you are throwing cash down the drain. Sludge causes the boiler to work harder to provide the heat you need.

Sludge puts pressure on all working parts within the heating system and will additional time cause blockages within the system inflicting a system breakdown.

The thermal imaging camera can decide in case you are affected by sludge build up within your system and point you in the fitting direction as as to whether you need a powerflush or not.

Checking The Powerflush Has Cleaned The System

Once the powerflush has been carried out, the thermal imaging camera can be utilized to check that everything is clean. Images might be taken and stored then forwarded on to the client with a report on the condition of the central heating system.

Advantages Of Using The Thermal Imaging Camera

The thermal imaging camera will discover hidden problems quicker than regular process of lifting floors and searching for the problem.

Determine if the central heating system truly wants a powerflush.

Provide proof to the shopper with images that the powerflush has been completed correctly.

Locate underfloor heating pipe routes and detect any points that may be present.

The thermal imaging camera has many benefits for the heating and plumbing engineers, to your customers, it makes you look more skilled, and can herald more work once the word gets around.